Triple Band MCPA Inline Booster 43dBm 20W
Model No.: CRF-MCPA182126-B343
Repeaters system is designed to solve problems of weak mobile signal, which is much cheaper than adding a new Base Station (BTS). The main operation of the RF Repeaters system is to receive a low-power signal from BTS via radio frequency transmission and then transmit the amplified signal to the areas where network coverage is inadequate. And the mobile signal is also amplified and transmitted to the BTS via the opposite direction.
High linearity PA; High system gain;
Intelligent ALC technology;
Full duplex and high isolation from uplink to downlink;
Automatic Operation convenient operation;
Integrated technique with reliable performance;
Local and remote monitoring (optional) with automatic fault alarm &remote control;
Weatherproof design for all-weather installation;
Expand signal coverage of fill signal blind area where the signal is weak or unavailable.
Outdoor: Airports, Tourism Regions, Golf Courses, Tunnels, Factories, Mining Districts, Villages, etc.
Indoor: Hotels, Exhibition Centers, Basements, Shopping Malls, Offices, Parking Lots, etc.
It is mainly applicable to such cases:
The repeater can find an installation place that can receive pure BTS signal at a strong enough level as the Rx Level in the repeater site should be more than -70dBm;
And can meet the requirement of antenna isolation to avoid self‐oscillation.
|Frequency Range (MHz)||1800 MHz||1710-1785||1805-1880|
|Max. Output Power (dBm) (Max. Gain, Center Frequency )||-15±2||43±2|
|Max. Gain (dB) ( Center Frequency ) @Optical Loss=0||45±3||45±3|
|ATT Adjustable Range (dB)||0 ~ 20||0 ~ 20|
|ATT Adjustable Step (dB)||1||1|
|ATT Adjustable Error (dB)||≤ |±1.5|||≤ |±1.5||
|ALC Range (dB)||0-20||0-20|
|Noise Figure (dB)||≤ 8||—-|
|Input VSWR(Power up, Min Gain, Pin=-30dBm)||≤ 1.8||≤ 1.8|
|Ripple In-Band (P-P) (dB)At +25℃||1800 MHz||≤ 7
|2100 MHz||≤ 7|
|2600 MHz||≤ 7|
|3rd Inter-modulation attenuation (dBc)
(Max. Gain, Dual-tone interval of 600KHz)
|EVM (Error vector margin)(%)RMS||≤ 6|
|Spurious Emission (dBm)
at out of band offset ±10MHz
|Time Delay (us)||≤ 5|
|Input / Output Impedance||50Ω|
|Power Consumption (W)||≤220|
|Temperature Range (℃)||-5 ~ +45|
|Control Function||Local Monitor||USB|
|Remote Monitor||SMS(4G Modem)|